Prepped cut outs and jigged horizontal stabilizer for bonding into fuselage. Applied first two layers to inside of fuselage to horizontal.

Laminated remaining layers around inside of horizontal and let cure.

Laminated two layers around both sides of horizontal where it exits fuselage.

Cut horizontal stabilizer tips for fabricating the counterweights.  Laminated the front portions to the stabilizer.

Bonded rear portion of elevator tips to elevators.  I used two layers on the outside for the initial layup and will add two layers to the inside after that cures.  The GI's had a problem with cracking at the inside corner.  This should prevent it.

Sanded the final gap between the horizontal and elevator.  Laminated ends of horizontal to finish closing out this area.

Sanded laminates of elevator counterweight cutouts on horizontal stabilizer.

Finished capping and filling horizontal stabilizer ends at counterweight cutouts.