Attached rudder hinge halves to right rudder and right vertical fin with hot glue.  Checked for proper fit then drilled holes and clecoed hinges in place.

Trimmed rudder shearweb for fitting left skin.  Laminated rudder actuator fitting shear web in place.  Fabricated rudder actuator fitting and treated it with alodine.  Trimmed and sanded left vertical stabilizer for fitting of left rudder skin.  Fabricated rudder shearweb extension and built support dams.  Attached actuator nut plates with mill-fiber.

Partially closed rudder by applying mill fiber to top of actuator rib and applying two layer laminate to rudder shearweb.  Jigged rudder straight and weighted down to cure.

Fabricated rudder ribs and bonded in place inside right rudder skin. Applied laminates inside rudder counter-weight area.

Poured counter-weight into rudder and laminated area closed. Bonded left rudder skin to ribs and closed trailing edge.

Hung rudder on plane.

Cut a part of the seat pan cutout for vertical cap closeout. Bonded cap in place and let cure

Trimmed and sanded vertical cap to match rudder